Secure IT infrastructures require special protective conditions. The requirements for structural fire protection are NOT sufficient for IT hardware! The standard structural fire protection acc. to EN 1363 (for standard buildings) and the fire protection acc. to EN 1047-2 (IT fire protection) are quite different.
The IT security room DC-ITRoom GranITe was successfully tested and certified according to the most stringent IT fire protective standards of EN 1047-2.
The IT security room QuartzITe 9.3 and the mini data center DC-ITSafe not only meet the requirements of the standard fire protection but also the compliance with the limit values of EN 1047-2 for 30 minutes.
Test procedure for the protection against high explosives placed near the objective and the resulting shock wave.
The IT security room DC-ITRoom GranITe successfully passed the explosion test following EN 13123-2/13124-2 and is a milestone for physical security systems for the protection of IT infrastructures.
Following EN 1630 IT security rooms are tested by manual burglar attempts using different tools.
The following table reflects the differences between the standard test procedures.
|Requirements and classification||Test procedure for the determination of the resistance under static loads||Test procedure for the determination of the resistance under dynamic loads||Test procedure of the determination of the resistance against manual burglary attempts|
The IP code according to EN 60529 consists of separate codes for dust and water protection. These codes
provide information about protective qualities and product tightness.
The IT security products of RZproducts are classified with the IP code 56 acc. to EN 60529.
© RZ-Products GmbH